A mitred corner is a 45 degree seam
continue this tutorial by clicking below
Draw a line with a Hera Marker on both borders
Fold and press the edges with an iron
Position the pressed edge on top of the 2nd mitred line,
then apply a tiny amount of Elmer’s Glue
along the inside edge and press flat
Leave open a 1/4 of an inch from the edge. The pin indicates where 1/4 inch is. You leave this 1/4 inch open to attach the centre of the quilt top later on (blocks)
No comments:
Post a Comment
Thank you so much for commenting. I moderate comments to block spam so don't worry if your comment doesn't appear instantly.
Note: only a member of this blog may post a comment.